THE DIELECTRIC RESONANCE & ENERGY PROPERTIES
OF RUBY, EMERALD, DIAMOND, SAPPHIRE & OTHER CRYSTALS

Ruby raises the skin and body temperature, increases the metabolic rate, circulation and muscle tension, being beneficial for patients with a large, heavy body type, and a slow, cold physiological disposition. It is contraindicated and is not for the agile, quick, and hot tempered physiological types.The effects of ruby and emerald can be scientifically confirmed by monitoring a patient’s pulse or by using a thermometer or a blood pressure monitor before and after treatment with gem medicines.

In contrast, emerald emits cold, green rays and is used to treat diseases arising from too much heat, such as burns, contusions, anorexia, diarrhoea, irritable bowel syndrome, stomach ulcers, cystitis and eczema. The green rays of emerald lower skin and body temperature, reduce libido, slow the metabolic rate and circulation, relax muscle tension and increase the patient’s body weight

Back in the early 1990's I  (Jon Whale) had occasion to treat a young child who was covered from head to toe with eczema. This prompted me to perform a series of controlled experiments testing the effect of the dielectric resonance using ruby and emerald transducers on the conductivity of my own skin. Under hyperthermic conditions for example, extensive vasodiliation occurs and the electrical resistance of the dermis decreases in Ohms per cubic centimetre. The results were very interesting and presented conclusive scientific evidence of the benefits of electronic gem lamp therapy for controlling and treating disease. The experiment was set up to prove the effectiveness of  transducers containing rubies for increasing local circulation and emerald for reducing circulation in the dermis. The placebo control was ordinary "colour therapy" lamps, the same lamps and filters being used for the control, but without gem stones fitted inside them. (This experiment was very similar to the temperature measuring experiment in Figure 6.4 and Figure 6.5 in Chapter 6 of my book: The Catalyst of Power). Furthermore, the following experiment substantiated the results of that test.The details of the experiment are as follows:

1) I marked off two areas of my left forearm with a fine marker pen as area ‘A' and area ‘B'.

2) Inside the centre of the area, I measured the skin resistance of both sites ‘A' and ‘B', using a calibrated ohmmeter with gold contact skin probes attached. The distance between the probes was fixed at 2 centimetres. These readings were:

Site ‘A' = 52,000,000 ohms (red placebo control lamp)

Site ‘B' = 47,000,000 ohms. (red lamp containing 6 rubies)

3) Area ‘A' was treated for five minutes with the red placebo control lamp.

4) Area ‘B' was simultaneously treated with the second red lamp containing 6 rubies of a size of 6 x 8 millimetres. The frequency used to stimulate the rubies was 8.3 HZ.

5) After five minutes of treatment the readings were taken again as follows:

Site ‘A' = 83,000,000 ohms (red placebo control lamp)

Site ‘B' = 27,000,000 ohms. (red lamp containing 6 rubies)

The results showed the site treated by the colour therapy placebo red lamp had increased by 31,000,000 ohms and that treated by ruby had decreased by 20,000,000 ohms.

I was surprised to discover and prove that the placebo lamp actually increased the electrical resistance of the dermis by drying it out whereas the gem therapy lamp containing rubies decreased the skin resistance by stimulating circulation, bringing blood and body fluids closer to the surface of the skin.

Twenty minutes later, the same experiment was carried out on my right arm using a green placebo lamp and a second green lamp filled with 6 emeralds as above.

Skin resistance before treatment was:

Site ‘A' = 23,000,000 ohms. (green placebo control lamp).

Site ‘B' = 28,000,000 ohms. (green lamp filled with 6 emeralds).

A Quantum Mechanics Article By Sharon Bridgman. ITEC. BRCP

Piezo is from a Greek word meaning pressure. Piezo electricity relates to the electrical dielectric charges in quartz crystal when subjected to mechanical pressure (squeezing and tapping etc). The crystal will transduce the mechanical frequencies of the stress into electrical frequencies and voltages.

Conversely when alternating electrical voltages are applied to (or near) a quartz crystal, then the crystal will mechanical vibrate. The Piezo Electrical (P.E.) effect of quartz crystal is a scientific principle, used in television, radio and medical equipment, such as ultra sound diagnostic apparatus and ultra sonic therapies. These make use of the natural P.E. effect of quartz and other crystalline substrates for transmission and receiving. For the P.E. effect to function, the crystal must be connected into an electronic circuit so that the kinetic energy is transformed into electron flow within the circuitry of the apparatus (1).

This inter-relationship of mechanical vibration and electrical oscillation makes the P.E. crystal a suitable vehicle for conversions from sound to electrical energies., particularly were sensitivity to high frequencies is desired. This quantum mechanical principle is well known and is widely used in all types of manufactured products. Microphones, Radio and television receivers and transmitters, computers, I-pods, mobile phones, chronographs. All of the above employ silicon chips (integrated circuits). In the early electrical gramophones the P.E. crystal acted as a link in sound reproduction via the needle, the quartz was pressurised by the music etchings in the record’s groves. In the field of telecommunications, the P.E. phenomenon is applied to improve methods of frequency stability.

A number of crystalline materials possess the P.E. property, but with the possible exception of tourmaline, quartz is the only mineral in which this property can be put too practical use for the purposes stated above. Liberating the electrical charges when the crystal is stressed is a function of electrical asymmetry within the atomic groups of which the crystal is built.

Inside the crystal, the constituent atoms are arranged in a definite pattern that is repeated at distances having atomic dimensions. Silicon and oxygen atoms bond with each other and produce molecules of silicon dioxide gas (Si02) which crystallises in the Earth’s magma . Positive charges are shown carried by silicon atoms (+), negative charges by double oxygen atoms (-). (See Figure 1. Below).

Figure 2 shows an isolated atomic group where “A” is the unstressed atom: positive and negative charges (associated respectively with the silicon and oxygen atoms) are coincident and the material is electrically neutral. In case “B” if the group undergoes a tensile stress, electrons are displaced. The centre of action of the three positive charges, moves away from the centre and an ‘electrical moment’ results. This separation of charges exists for all the atomic groups within the crystal. The net result being, the appearance of charges at the external boundaries along a particular axis. The polarity is reversed on the application of a compressional stress. An alternating voltage results from mechanical “pushes and pulls”.

Quartz is also pyro electric and additionally, it will resonate when influenced by electromagnetic fields. The resonate frequency is entirely dependent on its physical size. The smaller the size, the higher the resonant frequency. Thin slices will resonate at millions of cycles per second.

Quartz crystal, when used, holds and produces a flow of energy (Figures 6 &7): In the case were quartz or other crystal substrates are subjected to any kind of kinetic energy or electro magnetic stimulation; And not connected into an electrical circuit, then the energy is dissipated via dialectical resonance into the local environment.

It should be understood that the internal atoms of the crystal are bonded to each other by their valance electrons. In the case of the atoms at the crystal’s surface, three electrons of each atom are not bonded to anything Figure 1. These electrons are ‘orphan’s’ and they generate a electrical potential. There only connection is the local environment via capacitance.

This scientific fact is the key to understanding why many pure crystalline substrates dissipate energy into the environment. The un-bonded electrons at the surface cause a dielectric tension causing resonant turbulence within the crystal. This resonation is transmitted to the local environment, at the same time, the environmental energies is received by the crystal. Therefore, the crystal transmits its resonant frequency to the environment.

This scientific fact cannot be denied. If this were not true then today, we would be using mechanical typewriters, and cranking the handle of clockwork gramophones.

It is possible to energise quartz crystal using one’s own energy via contact with the hands (Figures 6 & 7). By doing so, the surfaces of the crystal become charged by heat and kinetic energy and will resonant. Silk cloth is an insulator, stroking the crystal with a silk handkerchief in one direction only towards the point, will significantly increase energy output from the crystal’s point by electrostatic energy.

By using these natural properties of quartz it is possible to transmit or receive a charge to or from a third party (local environment). Large quartz crystals make convenient tools for correcting the location and entry angle the human Assemblage Point’s (1,2). Assemblage Point therapy can rapidly treat conditions such as hypertension (anxiety, panic etc.) and hypotension (depression, chronic fatigue, etc.). In respect of Assemblage Point correction, the crystal acts like a magnet to attract and move the assemblage point.

The outermost form of quartz is a hexagonal prism, often terminating at the point in the shape of a hexagonal pyramid. Quartz is formed in the Earth’s magma. Left and right handed crystals grow naturally in clusters called ‘Massives’, the one being the atomic mirror image of the other (Figure 4).

The P.E. properties vary according to the direction in which the crystal is cut with respect to the X axis parallel to the crystal face or the Y axis, right angles to the crystal face (see Figure 3). “Left” hand crystals are the best for assemblage point corrections. These crystals grow on the gravitational perpendicular line in the cluster rather than at a slight angle and can therefore frequently provide six perfect triangles at the point.

When choosing a crystal for assemblage point correction therapy, it is advised that it should sit in the palm of the hand comfortably, with at least 6.0 cm. showing above the hand. Practitioners with a lot of personal energy will be able to use smaller crystals to shift assemblage points. For those who do not have an excess of energy, it is advised to employ a larger sized crystal with a weight of at least 200 grams.

Only large clear quartz and light rose quartz wands will work to shift and align the assemblage point. Amethyst wands will work, but less so, obtaining a large specimen is almost impossible. Amethyst is also quartz, but with manganese included and this gives it its purple colour. Another point for AP shifting, it is absolutely essential that the end that is held to the chest is slightly convex (domed) and polished finely. It must have the correct crystalline atomic orientation. This means that the point of the crystal must have a minium of 3 perfect triangles out of the six faces.

Beautiful coloured wands of other materials such sodalite, obsidian etc. are useful for ornamentation. So far as their use for shifting and correcting the location and alignment of the human Assemblage Point, they posses little or no dielectric resonance properties. This is due to contamination by insulators such as asbestos, mica and conductors such as iron, manganese, titanium, etc. These inclusions seriously disrupt and interfere with the silicon crystalline integrity. Smokey quartz is said to obtain its colour from ionising radiation from radium.

The energy emitted by quartz has been scientifically proven using as special electronic meter with anode and cathode telescopic aerials designed by Jon Whale. This meter will measure the energy emissions of quartz crystals and indicate the polarity (positive/negative) of the emissions at a distance of several metres. The other types of ornamental crystals mention above were tested, but the did not register any significant emission on the meter.     QED.

About Sharon Bridgman

Sharon Brigdman is a jeweler and craftsman in precious metals. Trained in Assemblage Point diagnostic and correction procedures, electronic gem therapy and infrared radiometric diagnostics. Registered with the Institute Of Complementary Medicine (ICM), and also The British Registrar of complementary therapists (BRCP).

References & Bibliography.

1. Renton. R.N. - Telecommunication Principles. Pitman. 1950

2. Whale, J. Naked Spirit - Supernatural Odyssey. Sub-titled: The Physical, Psychological, Emotional & Spiritual Maps For Health And Disease, Including the Assemblage Point Blueprints. This book is supported with nearly 300 illustrations. Available in paperback and full colour E-Book. Dragon Rising Publications 2006. ISBN 1-873483-06-6

3. Whale, J. The Catalyst of Power - The Assemblage Point of Man. (Second Edition). Available in paperback and full colour E-Book. Dragon Rising Publications 2006. ISBN 1-873483-05-8

Copyright: © Sharon Bridgman 2007. Licenced to Whale Medical Inc. All Rights Reserved.

 

Figure 2. Shows an isolated atomic group. 
 

Figure 3. LEFT = Y axis, Right angles to crystal face.RIGHT, X axis, parallel to the crystal face.

Figure 4. LEFT = left hand quartz crystal. RIGHT = right hand quartz crystal.




Figure 5. Assemblage Point shifting quartz crystals.

Figure 6. Arresting the Assemblage Point with a crystal.



 

Figure 7. Checking the crystal for energy activity.