Plasma Fusion Motor

3/10/01: "One" heretofore unheard of property of my device is the ability to LOOSE heat during normal operation, see clip titled: Thermal Video of Negative System Entropy (NSE). Conventional electromechanical systems produce heat as current is supplied to their systems, this is well known. What the video evidence clearly proves - heat is instantly lost from the electromagnetic conductors and attached wires. The focal point of the thermal image is a small cone of tightly wound 14 ga bare wire, and each winding is separated by a small gap. This small coil is positioned in series with the main power circuit and the rating of the Acopian power supply is 60 watts and the unloaded voltage is 353DC. Thermal Imager selection is in "Normal" mode with no isotherm highlighting and the range is set to "2". Time of power application in this test is 2 - 3 seconds. Please note the right and central lead turns black instantaneously as does the main body of the coil. I would hope some members are familiar with Thermal Imager protocol and know that under a setting of "normal" (not inverted) any cooling will proceed from lighter to darker and heating will proceed from darker to lighter.

3/12/01: Further Thermal Imaging video was attempted, however the "lucky tinkering" repairs I had made to it have failed, and as AGEMA no longer will repair the 750 model - I will attempt to locate the problem. I feel fortunate to have been able to produce the short clip, however I would not expect further thermal evidence as zero funds will not allow it.