Sorry, I hit the enter key a bit too soon on this, here is
the rest of what I wanted to add from this URL courtesy of
Bert Pool;
The present invention takes a transmission of energy, and
instead of sending it through normal time and space, it
pokes a small hole into another dimension,
thus, sending the energy through a place which allows
transmission of energy to exceed the speed of light.
First, you need to create a hot surface that is more than
1000 degrees Fahrenheit.
Next, it requires a strong magnetic field. Then, you need an
accelerator, followed by an electromagnetic injection point.
For communications or data communication, you need 2
devices. Each device is connected to a transmitter and
receiver. This allows electromagnetic energy to enter a
dimension and to travel at speeds faster than the speed of
light.
The magnetic fields are focused onto the heat generating
device.
The electromagnetic injection point is the plane generated
by the two opposing magnetic fields.
It has been observed by the inventor and witnesses that
accelerated plant growth can occur using the present
invention.
For accelerated plant growth, first, you need to create a
hot surface that is more than 1000 degrees Fahrenheit. Next,
you need a strong magnetic field.
Only one device is needed for this function. This allows
energy from another dimension to influence plant growth.
The preferred embodiment is an additional piece of equipment
that connectsto an existing communications device in place
of its original antenna. This device changes the medium of
transmission and reception of electromagnetic waves.
This allows the transmission and reception of
electromagnetic radio signals to exceed the speed of light.
The following is a description of how the preferred
embodiment known as the Hyper-Light-Speed Antenna is
constructed.
1. R5 is a 620-watt Halogen pencil lamp approximately 12
inches long with a diameter of approximately 0.3 inches.
Power to the lamp is supplied at the ends of the lamp.
2. The accelerators are a thin piece of wire wrapped around
the glass lamp. (This is for circular polarization). For
linear polarization, two thin pieces of wire are attached to
the lamp. One wire runs down one side of the lamp, the other
wire runs down the other side of the lamp (180 degrees from
each other). The spacing is not critical but must have
enough spacing to prevent arcing between the accelerators.
Theaccelerators operate at +2000 V DC on one accelerator and
-2000 V DC on the other.
3. This assembly goes inside a tube approximately 10.3
inches long--this length is not critical. Diameter of the
tube is approximately 1.1 inches.
4. Heat insulating material is installed on the tube.
5. Coil forms are installed on the tube, the forms CF1 and
CF3 are 4.3 inches long. These forms are then wound with
2500 turns of 22 AWG wire.
6. The coils are wired so both Magnetic Norths are toward
the center of the tube. (The unit can be set so both
Magnetic Souths are toward the center.)
7. In the middle of the tube there is 0.4 inches for the
magnetic injection assembly L2.
> Bert Pool sent in this new patent on a new hyper-light speed
> antenna and Bert noted the comment about accelerating plant
> growth;
>
> http://www.patents.ibm.com/details?&pn=US06025810__
>
-- KeelyNet - From an Art to a Science Jerry W. Decker - http://www.keelynet.com/discussion archives http://www.escribe.com/science/keelynet/KeelyNet - PO BOX 870716 - Mesquite, TX 75187 - 214.324.8741------------------------------------------------------------- To leave this list, email <listserver@keelynet.com> with the body text: leave Interact list archives and on line subscription forms are at http://keelynet.com/interact/ -------------------------------------------------------------