Puharich Patent/BRS OFF TOPIC
Harvey Norris ( (no email) )
Wed, 17 Feb 1999 20:50:04 PST
Jerry Decker wrote;
> > > Whereas Keely claimed that by instantaneously disrupting the
molecule,
> > > it would produce a tremendous explosion using the 42.8kcps...other
> > > frequencies for triple dissociation were 610, 610 and 12kcps.
> > >
> > > I still find it encouragingly synchronistic and supportive that the
> > > late Henry (Andrija) Puharich found that the optimum dissociation
> > > frequency for water was 600cps which he happened to stumble upon
while
> > > looking for a way to remove gases from the blood. When we had him in
> > > Dallas, I told him about Keely's research with water dissociation and
> > > named those frequencies, he'd never heard that before, so he was
> > > surprised also.
In pouring through Puharich Patent no 4,394,230 it would appear to me that
he is using an AC input.His claims at the end of the patent;
1.A method for splitting water molecules into hydrogen and oxygen
comprising;
a)generating complex electrical wave forms matching the complex wave form
resonant frequencies of tetrahedral water molecules;
b)applying said generated wave forms in resonance to said water molecules to
shatter said molecules, thereby liberating hydrogen and oxygen.
Further on,
5. The method of claim 1,in which
a) the applied complex wave form is a signal in the
form of an audio frequency,amplitude modulated carrier wave;
c)the impedance of said signal is matched continuously with that of said
cell during the electrolysis of said molecules.
6. the method of claim 5,in which the audio frequency is in the range of 20
to 200 Hz; and the carrier wave is in the range of 200-100,000 Hz
This amplitude modulation of a carrier wave is described as a novel
application of circuitry disclosed in earlier Puharich patents. Anyone know
where I can get copies of these through some kind of patent search engine on
the internet?
I have the no.s. 3,629,521 ; 3,563,246 ; 3,726,762.
In the available patent info stage C is said to contain the relevant
optimum efficiency;
fundamental carrier frequency=3980 Hz
1st Order Harmonic Modulation=7960 HzH
2nd Order Harmonic Modulation=15,920 Hz
3rd OHM= 31,840 4th OHM=63,690
What is believed to be happening in this IV OHM effect is that each of
the four apices of the tetrahedron water molecule is resonant to one of the
four harmonics observed.
Concerning this special electrical generator classified as Component 1
in the patent:
The energy output of Component 1 is an alternating current looking into a
highly non-linear load,i.e., the water solution. This alternating current
generator (Component 1) is so designed that at peak load it is in
resonance,and the vector diagrams show that the capacitive reactance and the
inductive reactance are almost exactly 180 degrees out of phase,so that the
net power output is reactive, and the dissipative power is very small. This
design insures minimum power losses across the entire output system. {Note:
we must deduce that the corresponding correct inductance to produce a
cancelling inductive reactance is then contained in the Component 1
circuitry. This is exactly the strategy I am employing in the construction
of a binary resonant electrolysizor. Assuming the cell to be essentially a
dead short condition the application of 120 volts rectified dc from wall
voltage must be limited by amperage or breakers will trip. The usual method
is to put a capacitor in series with the rectification circuit thereby
limiting the total amperage by the capacitive reactance of the cap. However
the method of using an inductor instead is far superior because a tank
circuit can then be formed where the volume of amperage inside the circuit
exceeds the volume of amperage inputed. Needless to say it is the volume of
amperage conduction that determines gas production and not voltage. The
primary problem concerning input voltage is that each cell produces the best
efficiency @ of a 2 volt dc pulse. Ordinarily any voltage past this does
not correspondingly increase the volume of gas generated thus involves a
loss of efficiency showing as wasted heat in the cell. However a resonant
voltage could be pulsed in such an effect that the voltage rise is
instantaneously cut off to that enabling the conduction value to take place.
In this new condition the binary resonant system will offer the correct
voltage value to any series of cells: it will deliver the minmimum voltage
necessary for conduction within realistic voltage parameters as determined
by the amount of resonant voltage rise available. Thus it will supply 40
volts to a 20 series cell: 80 to a 40 series cell: and only 2 volts to a
single cell. THE IMPLICATION OF THIS IS CONTAINED NOW IN THE FACT THAT
BEFORE THE STATE OF THE ART IN ELECTROLYSIZOR DESIGN HAS BEEN A SERIES OF
120 CELLS ACROSS A 240 AC INPUT SO THAT 2 VOLTS CAN EXIST ACROSS EACH CELL.
BUT THE BRS CIRCUMVENTS THIS PROBLEM SO THAT A PARALLEL INSTEAD OF SERIES
DESIGN CAN BECOME PRACTICAL. THE ADVANTAGE OF THIS IS THAT THE ACTUAL
RESISTANCE OF THE CELL AND THEREBY AMOUNT OF AMPERAGE CONDUCTION TAKING
PLACE CAN BE INCREASED BY CORRESPONDINGLY LARGER SURFACE AREA OF PLATES. IT
IS THE AVAILABLE AMOUNT OF AMPERAGE AND AVAILABLE PLATE AREA THAT
DETERMINES WHETHER THE SAME 2 VOLTS CAN ALLOW 3 AMPS CONDUCTION OR 30A. THE
AMOUNT OF AMPERAGE AVAILABLE IS DETERMINED BY THAT AVAILABLE IN THE PARALLEL
RESONANT TANK CIRCUIT LIMITED BY THE COIL SYSTEMS IMPEDANCE. BY USING TWO
SETS OF 7500 FT OF COILED 18 GAUGE WIRE A PREDICTED 700 VOLT PULSE AND 3/1
OUTPUT AMPERAGE VS INPUT AMPERAGE CAN BE MAINTAINED FROM THE WALL 120 AC
VOLTAGE. THE USE OF A ROTARY ARC GAP THEN BECOMES NECESSARY IN LIGHT OF THE
FACT THAT THE PULSE OF 700 VOLTS IS COMPLETELY STORED IN THE CAPS AT MOMENT
OF POLARITY CHANGE. SIMILAR TO THE FUNCTION OF THIS DEVICE IN TESLA COIL
PRIMARIES THE SHORT TO THE ELECTROLYSIZOR SHOULD MOST EFFECTIVELY APPLIED AT
THIS POINT IN TIME AND ADDITIONALLY THE USE OF 4 ROTARY SWITCHES IN
COORDINATION COULD BE REALIZED TO PRODUCE A MECHANICAL DC COMMUTATION TO THE
ELECTROLYSER AT 120 PULSES PER SECOND. ORDINARY USE OF DIODES FOR THESE
PURPOSES CIRCUMVENTS THE POSSIBILITIES OF EMPLOYING AN AC MODULATION OF A
DC PULSE INHERENTLY MADE POSSIBLE BY THE BINARY RESONANT ACTION OF A
SPECIALLY TIMED ARC GAP. IN THIS EXPERIMENTAL SCHEME OF USING A ROTARY GAP
TO CORRECTLY DISCHARGE A CAP VOLTAGE IN TIMING IT IS ENTIRELY CONCIEVABLE
THAT THE STORED VOLTAGE AT THE REVERSE POLARITY IN THE SECOND HALF OF THE
CYCLE MAY NOT REACH THE SAME VALUE AS WHEN FORMERLY SHORTED OUT. I N THIS
CASE IT MAY TAKE A FULL CYCLE TO BUILD UP A FULL RECOVERY TO 700 VOLTS IN
WHICH CASE A PULSE OF 60 SHORTS PER SECOND COULD BE USED AS A MEANS OF HALF
WAVE RECTIFICATION THEREBY NEGATING THE USE OF 4 SWITCHES AS IN MECHANICAL
COMMUTATION. }Having gone quite off topic here seems to indicate what
happens in what Puharich terms a 'Open Circuit ' Reversible Threshold
Effect. This occurs when the water molecules are capacitor charging and
discharging at their characteristic low frequency RC time constant of 0.0002
seconds. It is to be noted that pure water has a very high dielectric
constant which makes such an effect possible.
{ Essentially a half wave rectification of the AC input@ 5000 hz is
accomplished perhaps when an inductive reactance to the acting capacitance
reactance of the electrolysis cell is matched at this frequency.
Irregardless a unipolar pulse is accomplished even though the input is 5000
hz AC. Amazingly this pulse only manifests itself in a 3 second cycle where
the pulsing amplitude modulation of the voltage is determined by the
hydrogen nuclear spin relaxation constant. I may have misinterpreted this
as a special function of component 1 or I may be over my head in trying to
understand this patent. any corrections are appreciated HDN}
_______________________________________________________
Get your free, private email at http://mail.excite.com/