Re: Searl Rotation a Thermal Effect?

Jerry W. Decker ( (no email) )
Fri, 01 May 1998 05:47:01 -0500

Hi Folks!

Here is another post from the pyromagnetics guy;

Jerry,I have read in the internet that NEWMAN is working on the
permanent magnet solenoid device....I began work on it YEARS ago I even
told ******** about a self regenerating jumping stick a LONG time
ago, SO, I don't want to hear about how I stole anything from Newman.

I don't Know the man, nor have I ever read anything at all about his
solenoidal F.E. Device...I do Know this, Tesla SAID 100 years ago that a
large Piston supported by an air filled cylinder would oscillate almost
indefinetly once set into motion.

OBVIOUSLY if the Piston was a magnet and the cylinder non-magnetic or
conducting its oscillations would be, via a coil, a perfect source of
A.C. power just like my jumping stick.

We did not consider one other possibility I worked on extensively in
case the pulsing effect proved unable to regenerate the capacitor AND
that was to put the MAGNETIC PISTON INTO A LONG CYLINDER with its bottom
cavity at S.T.P. and through feedback from our coil, drive an
incandescent (I.E. nichrome, toaster elements) air heater above the top
of the oscillating air spring magnet's cylinder and by the induction of
a partial vacuum caused by a vortex keep the MAGNETIC PISTON OSCILLATING
INDEFINETLY.

The application to the JUMPING STICK was to use the Conical hats
induction venturi to pull air out of the top of the solenoidal stick and
since the suction is naturally unstable from the conical hats venturi
the magnetic piston would oscillate perpetually and not rely soley on
mechanical instability of the arm holding the solenoid stick or fee.

ONCE again we return to ADAMSKI'S drawing and see three pipes coming out
of his central magnetic pole leading to three vents above the conical
flange. If it works the heater coil above the conical flange would
maintain a constant updrart sucking air out those tubes connected to the
magnetic pole and our bouncing magnetic piston.

IN OTHER WORDS UNSTABLE AIR CAREFULLY DIRECTED COULD KEEP THE PISTON
BOUNCING.....CONSIDER IT. A HOUSE GENERATOR COULD BE BUILT WITH THE
MAGNETIC BOUNCING PISTON WITH THE TOP OF THE CYLINDER BEING CONNECTED TO
A CHIMNEY PIPE SINCE NO DIRECT AIRFLOW FROM THE HOUSE IS INVOLVED (ITS A
PRESSURE RESONANCE) NO PRECIOUS INDOOR AIR (AIRCOND, OR HEATING WOULD BE
LOST UP THE CHIMNEY).

I HAVE DONE A FEW EXPERIMENTS TOWARD THAT END. I'M SURE FROM WHAT I'VE
READ NEWMANS NOW WORKING ON THE SAME IDEA ONLY STRICTLY IN THE PULSED
FEEDBACK AREA NOT THE AEROMECHANICAL METHODOLOGY I JUST DECRIBED SO IF
THE P.F. DOESNT WORK TO YOUR LEVEL OF SATISFACTION. WE HAVE OTHER WAYS
TO KEEP THAT SOLENOIDAL MAGNETIC CYLINDER OSCILLATING AS A FREE ENERGY
SOURCE.

I THINK TESLA KNEW THAT 100 YEARS AGO AS USUAL WHAT A GENIUS HE WAS...

--                Jerry W. Decker  /   jdecker@keelynet.com          http://keelynet.com   /  "From an Art to a Science"       Voice : (214) 324-8741   /   FAX :  (214) 324-3501   KeelyNet - PO BOX 870716 - Mesquite - Republic of Texas - 75187