Yes, I have that book and always PREFER to go to the ORIGINAL reports or
claims rather than the 'new age expansions' that come about once some
degree of notoriety or investment has been generated...:)
Your quote;
> The armature was set in motion by a small engine.
answers the first question, that it was driven by an outside source. It
also plays a major part in answering question #3 because his 'new
magnet's' have a spin created in them by a mix of elements. The purpose
of this spin is to make the disk self-powering, no need for an outside
motor to drive it.
You also write;
> Now a couple of question:
> 1)What did he use in the original?
> 2)Can it be demonstrated again?
> 3)Why does he now claim to need expensive magnets when he first
> achieved the effect cheaply and at a very low cost?
If there is any truth to it, then #2 should be able to be duplicated
since it is all off the shelf except for the disk itself...and that could
well be a sheet metal or bicycle rim, maybe with U magnets at the rim to
increase electron accumulation.
-- Jerry W. Decker / jdecker@keelynet.com http://keelynet.com / "From an Art to a Science" Voice : (214) 324-8741 / FAX : (214) 324-3501 KeelyNet - PO BOX 870716 - Mesquite - Republic of Texas - 75187